If you are an Electrical Contractor,
you always seek for the best tools that have an edge over the other products.
This could be achieved if you get your tools from a company that focuses on
innovation and ongoing Research & Development (R&D). iToolco is one
such company that has developed and patented 25 successful products. These have
the top sellers in the international market. The founder of the company had
been an electrical contractor and understands the kind of quality, durability
and time-saving tools needed by electricians.
You can reach them over phone number 865 670 3713 or can visit them at
100 Meco Ln, Oak Ridge, TN 37830, USA. The following are brief particulars of
their product.
●
Gear
Punch Knockout Kit ½” to 2”
This is made from mild and stainless
steel by adopting the Slick-Cut technology. The punches and dies allow cutting
of ½” through 6”, up to 10 gauges of MS and SSS. The gear punch is compatible to work with any model of corded and
cordless drill. In order to maintain alignment, the punches and dies are marked
with the trade standard conduit sizes and center point marks.
●
Maxis
Cable Puller
It can be taken to job site by one
person and has easy adjustment facility for uneven surfaces. The minimum drill
recommendation is 18V, which is equivalent to 1000 in lb, torque-rated. For an
easy pay off, the axle rests on steel rollers. The safety guard for axle
prevents falling off of jack stands. The Prozac stands can lift up to 10,000 lb
(pair). It can be used with 1-1/4” to 3” of axle.
●
Wire Puller;
Canon 6K
The Cannon 6K Wire Puller comes with dual capstans which can pull 8’ and 28’ per
minute with low speed and 20’ to 70’ per minute on high speed. The capstan has
4 speeds. It is a two wire puller. It is lightweight and can be transported
easily. It can quickly change from side pulling to overhead and underground.
●
Jack
Stand RJ6K
The Jack Stand has closed head traps that prevent the axle from falling
out or moving horizontally. Even on uneven ground, separate sides can be used
safely and does not tip over. It fits exactly to Wemco reels and can be used
with 22” to 66” spools. It can carry 35 lbs per side. Four bearings with 20,000
lb rating ensure smooth and easy pulling.
